Preparations At The Workplace; Operation - Hilti DX 76 Manual

Recommended maximum fastening rate
Max. contact pressure
Compression stroke
Ambient temperature (storage and use)
4.2 Noise and vibration information
The noise values listed were determined under the following conditions:
Noise information conditions
cartridge
Energy setting
Application
Noise information in accordance with EN 15895
Sound power level (LWA)
Emission sound pressure level (LpA)
Peak sound pressure emission level (LpC)
Vibration information in accordance with EN 2006/42/EG
Energy-equivalent acceleration, (a
5

Preparations at the workplace

5.1 Assembling the fastening tool
WARNING
Risk of injury by accidental triggering! A loaded fastening tool can be made ready to fire at any time.
Accidental triggering can endanger you and others.
▶ Always unload the fastening tool (cartridges and fasteners) whenever you interrupt work with the fastening
tool.
▶ Before all maintenance, cleaning and setup activities, always make sure that there are no cartridges and
no fasteners in the fastening tool.
1. Mount the piston stopper on the fastener guide (1).
2. Insert the piston into the piston guide (2).
3. Insert the piston guide (slider at top) into the housing.
4. Push the piston guide into the housing and lock the piston guide with the piston-guide locking lever (4).
5. Position the fastener guide on the piston guide.
6. Turn the fastener guide clockwise until it engages (5).
▶ The fastener guide is locked.
6

Operation

WARNING
Risk of injury by accidental triggering! A loaded fastening tool can be made ready to fire at any time.
Accidental triggering can endanger you and others.
▶ Always unload the fastening tool (cartridges and fasteners) whenever you interrupt work with the fastening
tool.
▶ Before all maintenance, cleaning and setup activities, always make sure that there are no cartridges and
no fasteners in the fastening tool.
WARNING
Hazard due to hot surfaces! The fastening tool can become hot in use.
▶ Wear protective gloves.
*282471*
6.8/11 caliber, blue
4
Fastening to 8 mm steel (400 MPa) using the X-ENP 19 L15MX
)
hw, RMS(3)
2
282471
600 fastener driving opera-
tions/h
≤ 240 N
32 mm
−15 ℃ ... 50 ℃
114 ±2 dB(A)
110 ±2 dB(A)
139 ±2 dB(A)
2.5 m/s²
English 21