Chrysler Pacifica 2021 Owner's Manual page 324

322 SERVICING AND MAINTENANCE
3. There are glove compartment travel stops on
either side of the glove compartment door. To
release them, push inward on each travel stop,
and pull the glove compartment door down
until the travel stops pass clear of their
hooking points.
4. Open the glove compartment door as far as
possible to gain access to the cabin air filter
compartment cover.
Cabin Air Filter Compartment Cover
1 — Compartment Cover
2 — Compartment Snap
5. Pry up the lid of each individual compartment
snap, and detach it from the rest of the snap.
There is a small space on the side of each
snap to use for separating the lid from the
snap. Once detached, remove the rest of the
snap completely from the compartment cover.
6. After removing the snaps, lift up the
compartment cover to gain access to the fresh
air inlet.
Fresh Air Inlet
1 — Filter Cover
2 — Retaining Tabs
7. Remove the filter cover by prying back each of
the retaining tabs from their hooking points,
and then pulling the filter cover out to expose
the cabin air filter. Remove the air filter by
pulling it straight out of the housing.
8. Install the new air filter with the arrow on the
filter pointing toward the floor.
CAUTION!
The cabin air filter is identified with an arrow to
indicate airflow direction through the filter.
Failure to properly install the filter will result in
the need to replace it more often.
9. Once the filter is replaced, reinstall the filter
cover, making sure the retaining tabs are fully
secured into their housings.
10. Close the cabin air filter compartment cover,
and reinsert the snaps into their slots. Push
the snap lids until fully attached.
11. Push the glove compartment door to the near
closed position to reengage the glove
compartment travel stops. Finally, pull the
glove compartment tension tether clip down
and slide it back into the slot on the side of the
glove compartment door.