NordicTrack CX 925 User Manual page 6

5. Identify the Left Pedal (10), which has a notch near
the right side. Place the Left Pedal on the Left Pedal
Leg (4). Next, apply the entire contents of one of the
included Teflon ® lubricant packets to the long side of
an M8 x 79mm Bolt Set (65) and the faces of the two
indicated Upper Body Arm Bushings (12). Have a sec-
ond person hold the lower end of the left Upper Body
Arm (29) inside of the bracket on the Left Pedal Leg.
Align the indicated holes, and attach the Left Pedal
and the left Upper Body Arm to the Left Pedal Leg with
the M8 x 79mm Bolt Set.
Attach the other end of the Left Pedal (10) to the Left
Pedal Leg (4) with two M8 x 54mm Button Screws (83).
Repeat this step on the right side of the elliptical exer-
ciser.
See step 2. Tighten the two M10 x 108mm Button
Screws (70).
6. The Console (17) requires four "D" batteries (not
included); alkaline batteries are recommended. Slide
the battery cover off the Console. Insert four batteries
into the battery compartment. Make sure that the bat-
teries are oriented as shown by the diagram inside
the battery compartment. Slide the battery cover
back onto the Console. Note: When the batteries are
installed correctly, the fan will turn on for a moment.
7. Remove the ground wire screw from the Upright (2).
Attach the ground wire to the Upright with the ground
wire screw as shown.
Have another person hold the Console (17) near the
Upright (2). Connect the ground wire to the ground
wire on the Console. Connect the Upper Wire Harness
(30) to the wire harness on the Console. Connect the
two Pulse Wires (20) to the pulse wires on the
Console.
Carefully insert all excess wiring down into the Upright
(2). Attach the Console to the Upright with four M4 x
16mm Screws (94). (Note: The Screws may be found
in the console box.) Be careful to avoid pinching the
wires.
8. Make sure that all parts of the elliptical exerciser are properly tightened. Cover the floor beneath the
elliptical exerciser to protect the floor from damage. Note: Some extra hardware may be left over.
The elliptical exerciser is now fully assembled. If you have purchased the optional chest pulse sensor
(see page 18), see page 7.
All manuals and user guides at all-guides.com
6
5
65
29
Lube
65
Face
Lube
12
4
6
Battery
Cover
7
17
Do not pinch
the wires
during this step.
30
2
94
94
10
Notch
5
83
17
Batteries
20
Ground Wire Screw
Ground
Wire