Table of Contents
Advertisement
This appliance is equipped with the "Multi-tab
function", that allows the use of the "Multi-tab"
combi detergent tablets.
These products are detergents with a
combined cleaning, rinsing and salt functions.
They can also contain other different agents
depending on which kind of tablets you
choose ("3 in 1", "4 in 1", "5 in 1" etc...)
Check whether these detergents are suitable
for your water hardness. See the
manufacturers instructions.
Once this function is selected it will remain
active for all following wash programmes.
Whit the selection of this function the inflow of
rinse aid and salt from each respective supply
container is automatically deactivated and
also the indicator lights for salt and rinse aid
are deactivated.
With the use of the "Multi-tab function", the
cycle durations may change. In this case, in
the digital display, the indication of the
running time of the programme is
automatically updated
IMPORTANT!
Activate/deactivate the "Multi-tab function"
before the start of a washing programme.
Once the programme is running, the "Multi-tab
function" can NO longer be changed. If you
want to exclude the "Multi-tab function" you
have to cancel the programme setting and
then deactivate the "Multi-tab function". In this
case you have to set a washing programme
(and desired options) again.
Activation/deactivation of the Multi-tab
function
Simultaneously press and hold the two Multi-
tab buttons (D and E) until the Multi-tab
indicator light illuminates. This means that the
function is active.
To deactivate the function press the same
buttons again until the indicator light
corresponding to the Multi-tab function symbol
turns off.
If the drying results are not satisfactory we
suggest that you:
1. Fill up the rinse aid dispenser with rinse aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position 2.
The activation/deactivation of the rinse aid
can only be possible with the Multi-tab
function active.
Activation/deactivation of the rinse aid
dispenser
1. Press the On/Off button. The dishwasher
must be in setting mode.
2. Simultaneously press and hold function
buttons B and C, until the lights of function
buttons A, B and C start flashing.
3. Press function button B, the lights of
function buttons A and C turn off while the
light of function button B goes on flashing.
The digital display indicates the current
setting.
4. To change the setting, press function button
B again, the digital display indicates the
new setting:
= Rinse aid dispenser deactivated
= Rinse aid dispenser activated
5. To memorise the operation, switch off the
dishwasher by pressing the On/Off button.
If you decide to turn back to the use of
standard detergent system we advise that
you:
1. Deactivate the Multi-tab function.
2. Fill up the salt container and the rinse aid
dispenser again.
3. Adjust the water hardness setting to the
highest setting and perform 1 normal
washing programme without loading any
dishes.
4. Adjust the water hardness setting according
to the hardness of the water in your area.
5. Adjust the rinse aid dosage.
19
Advertisement
Table of Contents
