Ripping - Grizzly G0605X Owner's Manual

Ripping

"ripping" means cutting with the grain of a natu-
ral wood workpiece. in other man-made materials
such as mdF or plywood, ripping simply means
cutting lengthwise.
Serious injury can be caused by kickback.
Kickback is a high-speed expulsion of stock
from the tablesaw toward an operator. The
operator or bystanders may be struck by
flying stock, or the operator's hands can be
pulled into the blade during the kickback.
To make a rip cut:
1. review preventing Kickback on page 10
and take the necessary precautions to pre-
vent kickback.
2.
if using natural wood, joint one long edge of
the workpiece on a jointer.
3. disConnECt thE saW From poWEr!
4.
Ensure that the blade guard and splitter or
riving knife is installed.
5.
set the fence to the desired width of cut on
the scale.
6.
adjust the blade height so the highest saw
tooth protrudes approximately
workpiece.
7.
set up safety devices such as featherboards
or other anti-kickback devices.
8.
rotate the blade to make sure it does not
come into contact with any of the safety
devices.
9.
plug the saw into the power source, turn it
ON, and allow it to reach full speed.
model g0605X/g0606X (mfg. since 11/06)
10. the jointed edge of the workpiece must slide
11. use a push stick to feed the workpiece
Turn Off the saw and allow the blade to
come to a complete stop before removing
the cut-off piece. failure to follow this warn-
ing could result in serious personal injury.
⁄ " above the
1
4
Keep the blade guard installed and in the
down position. failure to do this could
result in serious personal injury or death.
against the fence during the cutting opera-
tion.
through the saw blade, as shown in figure
43, until the workpiece is completely past the
saw blade.
figure 43. typical ripping operation.
-33-