GE Profile PFSF6PKX Owner's Manual & Installation Instructions page 42

Before you call for service...
Troubleshooting Tips
Problem
Water filter indicator
light changed color
Water filter indicator light
remains red even after
replacing the water filter
Water filter indicator
light is not lit
Handle is loose / handle
has a gap
Refrigerator beeping
Control setting is not lit
(non-LCD models)
LCD screen freezes
(LCD models)
Not cooling. OF/OF
appears in the display
Not cooling. OFF/OFF
appears in the display
42
Possible Causes
This is normal.
Water filter indicator must
be reset.
This is normal. This light will
turn orange to tell you that you
need to replace the filter soon.
The filter cartridge should be
replaced when the replacement
indicator light turns red.
Handle needs adjusting.
This is the door alarm.
On some models, the light
bulbs at the top of the refrigerator the light bulbs are burned out, and replace if necessary.
compartment light up the
temperature control settings.
LCD screen needs to be reset.
The cooling system is off.
The cooling system is off.
What To Do
• The water filter indicator light shows the following:
Green = Good
Orange = Change soon
Red = Change immediately
• See About the water filter for more information.
Non-LCD models:
• Press and hold the ICE & WATER pad for 3 seconds.
See About the water filter for more information.
LCD models:
• On the LCD screen, select SETTING, then WATER FILTER.
Select REPLACE and follow the instructions given.
• See About the water filter for more information.
• See Attach the Fresh Food handle and Attach
the Freezer handle sections for detailed instructions.
• Close door.
• If the control settings do not light up, check to see if
• Reset the LCD screen by inserting a paper clip into the
small hole next to the SD card slot under the front edge
of the dispenser opening (see Screen Functions: Photos
for location).
Non-LCD models:
• Press and hold the ADJUST FREEZER and ENERGY SAVER
pads at the same time for 3 seconds. You will hear a beep
and the OF/OF will disappear. You can now adjust the
temperature. Please allow 24 hours for the unit to cool to
your set temperature.
LCD models:
• On the LCD screen, select SETTING, SYSTEM and then
COOLING SYSTEM until a check mark appears beside
COOLING SYSTEM. Select HOME. You can now adjust the
temperature. Please allow 24 hours for the unit to cool
to your set temperature.