Maintenance - Vax VRS7W Series Instruction Manual

VRS7W Series User Guide v1.0.qxd:User Guide
While making sure the dirty water tank is resting on the
base, place the rear of the tank into the base of the
cleaner, push down on the handle until it latches.
Replace lid of dirty water tank by pressing it into place
(Fig 4/16).
Fig.4/16

5. Maintenance

Brush removal and replacement
NOTE: The plug must be disconnected from electrical
outlet before cleaning or maintaining the appliance.
Ensure both clean and dirty water tanks are removed
from the cleaner.
Flip the cleaner on its side to expose the nozzle base.
Lift out the floating brushbar by pressing the two latches
and pulling it gently (Fig 5/1).
Fig.5/1
Replace floating brushbar (Fig 5/2).
Fig.5/2
All manuals and user guides at all-guides.com
19/5/11 17:58 Page 7
Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308
Cleaning the tank filter
IMPORTANT: Do not use any detergents or boiling
!
water to wash the filters. Vax recommends
checking the filters every time the dirty water tank is
emptied.
NOTE: All filters must be in place before using your
!
machine.
1 Remove the dirty water tank from the unit.
2 Remove the filter cover from the back of the tank.
1
Fig.5/3
3 Separate the filter from the filter cover.
Fig.5/5
The filter can be rinsed in warm water (max. 40
! 40° C max
Fig.5/6
IMPORTANT: Ensure filter is fully dry before
!
replacing back into the machine.
operation/ maintenance
2
Fig.5/4
3
C)
°
24hr
7