Vax VRS7W Series Instruction Manual page 6

VRS7W Series User Guide v1.0.qxd:User Guide
vax.co.uk
Emptying the dirty water tank
Tipping the cleaner and breaking the seal of the
nozzle against the carpet will cause the float to rise
cutting off suction. Once the float is activated, empty
the dirty water tank. If the tank does not appear full
turn off the power switch and wait for the float to
settle. For best results only use Vax carpet cleaning
solution.
You will hear a change in motor pitch when the tank is full
and needs emptying.
IMPORTANT: Unplug your cleaner before
!
emptying the dirty water tank.
Grasp the top of the dirty water tank handle and press
the release latch. Lift off the lid ensuring that no dirty
water leaks from the front (Fig 4/10).
Fig.4/10
Remove dirty water tank (Fig 4/11).
Fig.4/11
6
operation
All manuals and user guides at all-guides.com
19/5/11 17:58 Page 6
To empty the water tank grasp the handle with one hand
and nozzle with the other, and empty into the sink
(Fig 4/13).
Fig.4/13
Cleaning the dirty water tank
Rinse the dirty water tank and lid thoroughly, with warm
water (Fig 4/14).
You should allow them to dry fully before replacing them
on your cleaner to prevent mildew.
Do not use any chemicals in the cleaning process.
Fig.4/14
Replacing the dirty water tank
Pull the handle and hook the front of the dirty water tank
into the base, making sure that the front of the dirty
water tank is resting on the base.
Failure to install the dirty water tank correctly will result
in poor dirty water pick up (Fig 4/15).
Fig.4/15