McCulloch B40 B Elite Operator's Manual page 8

6. Release the throttle and make sure that the cutting
attachment stops and remains at a standstill. Adjust
the carburetor if the cutting attachment move with
the throttle is in the idle position. Refer to the
instructions in the chapter
on page 22 .
To do a check of the stop switch
1. Start the engine.
2. Move the stop switch to the stop position and make
sure that the engine stops.
Cutting attachment guard
The cutting attachment guard prevents a loose object to
eject in the direction of the operator. Examine the cutting
attachment guard for damage and replace if it is
damaged. Only use the approved guard for the cutting
attachment.
8
To adjust the idle speed
To do a check of the vibration damping system
The vibration damping system decreases vibration in the
handles to a minimum which makes the operation
easier.
1. Stop the engine.
2. Do a visual check for deformation and damage, for
example cracks.
3. Make sure that the elements of the vibration
damping system are attached correctly.
To do a check of the quick-release mechanism
WARNING:
a defective quick-release mechanism.
The quick-release mechanism lets the operator remove
the product quickly from the harness if there is an
emergency.
1. Stop the engine.
2. Do a visual check for damage, for example cracks.
Do not use a harness with
1681 - 001 - 28.06.2021