Safety - McCulloch B40 B Elite Operator's Manual

Read the operator's manual carefully and
make sure that you understand the
instructions before use.
Use a protective helmet in locations where
objects can fall on you. Use approved
hearing protection. Use approved eye
protection.
Use approved protective gloves.
Use heavy-duty slip-resistant boots.
The product can cause objects to eject,
which can cause injury.
Maximum speed of the output shaft.
Keep a minimum distance of 15 m/50 ft to
persons and animals during operation of
the product.
Risk of blade thrust if the cutting
equipment touches an object that it does
not immediately cut. The product can cut
off body parts. Keep a minimum of 15
m/50 ft distance to persons and animals
during operation of the product.
Only use a flexible cutting wire. Do not
use metal cutting elements. Apply this for
grass guard accessory.
The arrows shows the limit for the handle
position.
Air purge bulb.
Safety definitions
The definitions below give the level of severity for each
signal word.
4
Fill fuel.
Choke.
Noise emissions to the environment
according to European Directive
2000/14/EC and New South Wales
legislation "Protection of the Environment
Operations (Noise Control) Regulation
2017". Noise emission data can be found
on the machine label and in
data on page 24 .
The product agrees with the applicable
EC directives.
yyyywwxxxx
Note:
Other symbols/decals on the product refer to
certification requirements for other commercial areas.
Product liability
As referred to in the product liability laws, we are not
liable for damages that our product causes if:
• the product is incorrectly repaired.
• the product is repaired with parts that are not from
the manufacturer or not approved by the
manufacturer.
• the product has an accessory that is not from the
manufacturer or not approved by the manufacturer.
• the product is not repaired at an approved service
center or by an approved authority.
Euro V Emissions
WARNING:
voids the EU type-approval of this product.

Safety

WARNING:
The rating plate or the laser printing
shows the serial number. yyyy is the
production year, ww is the production
week.
Tampering with the engine
Injury to persons.
1681 - 001 - 28.06.2021
Technical