Handlebar Switches - Yamaha YZF-R125 Owner's Manual

Instrument and control functions

Handlebar switches

Left
1
2
3
3
ZAUM1583
1. Dimmer/Pass switch "
2. Turn signal switch "
3. Horn switch "
Right
1
ZAUM1584
1. Engine stop switch "
2. Start switch "
Dimmer/Pass switch "
Set this switch to "
beam and to "
To flash the high beam, push the pass
side "PASS" of the switch while the
headlights are on low beam.
TIP
When the switch is set to low beam,
both headlights come on.
When the switch is set to high beam,
both headlights come on.
EAU1234M
/ /PASS"
/ "
"
2
/ "
"
EAUM4030
/ /PASS"
" for the high
" for the low beam.
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
starting the engine. Set this switch
to " " (stop) to stop the engine in case
of an emergency, such as in the event
of an overturn or if the throttle is stuck.
Start switch " "
Push this switch to crank the engine
with the starter. See page 5-2 for start-
ing instructions prior to starting the en-
gine.
The engine trouble warning light and
ABS warning light may come on when
the key is turned to "ON" and the start
switch is pushed, but this does not in-
dicate a malfunction.
3-12
EAU12461
/ "
". When
EAU12501
"
EAU12663
/ "
" (run) before
EAU12713
EAU42342