Replacing The Lower Board - Precor AMT12 Base Service Manual

22 Replace the upper arm cam covers.
23 Attach the vertical handle bar to the front arm.
24 Replace the main body covers as per procedure,

Replacing the Lower Board

WARNING: Before continuing with this procedure, review the Warning and Caution
statements listed in Section One, Things You Should Know.
Removing the Lower PCA Cover
1 Remove the main body covers as per procedure,
Replacement".
2 There are two interlocking pressure tabs located on each side of the lower PCA cover, push the two
locking tabs outward and pull up the bottom of the lower PCA cover.
3 Rotate the bottom of the lower PCA cover up until the two hooks of the cover disengage from the
lower PCA bracket.
Figure 207: Lower PCA Cover
Removing the Lower PCA
1 Attach the wrist ESD strap to your arm, and then connect the ground wire of the wrist strap to a
© 2012 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Cover Replacement.
Cover Replacement section
"Cover
(see
Page 127 of 214