Left And Right Bottom Cover Assembly; Left And Right Side Cover Assembly - Precor AMT12 Base Service Manual

2 The left and right side bottom covers can now be removed by lifting them up and out.
Figure 74: Bottom Covers Removed

Left and Right Bottom Cover Assembly

1 Set the left and right bottom covers in place, align the cover mounting holes.
2 Fasten the two covers together with the 8 #10 x ¾ inch screws.

Left and Right Side Cover Assembly

1 Grasp the side cover near the bottom, rotate the side cover so that the top of the side cover points
toward the front of the AMT and the round cover notch points up.
2 Thread the top of the side cover under the upper arm weldment and toward the front of the AMT.
3 Rotate the top of the side cover up until the round notch of the side cover meets the upper arm.
4 Push the bottom of the side cover in until the tabs of the side cover rest in the notches on the
bottom cover.
5 Repeat the Side Cover Assembly procedure for the right side cover.
Figure 75: Side Cover Assembly
© 2012 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Page 34 of 214