Sleep Mode; Selecting Units Of Measure - Napa CARLYLE DTW39FL Manual

Angle Mode Warning
NOTE:
When using the wrench in "
attempt is made to change values or to power up the unit.
If the user attempts these functions without following the instructions above the unit's display will begin to flash a series of
four zeros in the top half of the screen.
In order to reset the unit, remove the battery cover; then replace.

SLEEP MODE

• The wrench will automatically go into "Sleep" mode after
being idle for approximately 2 minutes to save power.
Press to wake from "Sleep" mode.
LOW BATTERY VOLTAGE PROTECTION
• If the battery voltage is below 2.3 volts, the wrench
will highlight the battery symbol and after a few
moments turn off.

SELECTING UNITS OF MEASURE

The torque wrench displays 4 different
units of measure plus angle:
1. Newton meters (N-m)
2. Inch Pounds (in-lb)
3. Foot Pounds (ft-lb)
4. Kilogram Centimeter (kg-cm)
5. Angle
Pressing the button allows you to
cycle sequentially though each of these units of
measure and the angle display.
DTW38FL, DTW12FL
ANGLE"
mode the wrench must be placed flat (horizontally) on table or workbench before any
IMPORTANT!
N-m
In-lb
7
ft.-lb.
Battery Indicator
Angle
Ft-lb
Kg-cm
Rev. 01/23/13