Peak Hold Mode - Napa CARLYLE DTW39FL Manual

PEAK HOLD MODE

Peak Hold Mode: This mode allows the operator to view and store individual torque values. Up to 50 values can
be stored. NOTE: The peak hold mode can only be used with a torque value previously stored
in one of the 9 Pre-Set memory locations.
Storing Peak Hold Values:
1. Using the button, navigate to the desired
preset value.
(e.g. M3, M4, M5 . . . etc.)
2. Apply load to the handle until the red light
illuminates and the alarm tone sounds, then release
the load.
3. The highest torque value reached during the
application shows and flashes in the display.
4. Pressing the
Note: Each time a value is stored, the location
number increases sequentially:
n001, n002, n003 . . . etc.
5. Pressing the button while the torque value is
flashing allows the operator to bypass this value and
not store it.
6. Repeat steps 1 through 4 until the desired number of
torque values have been stored.
NOTE: A maximum of 50 values can be stored in memory.
The word "FULL" appears in the display when an attempt is
made to store more than the allotted maximum.
Viewing Peak Hold Values:
1. Press and hold the
"nodE" appears in the display.
2. Press button again. "AU-1" appears in display.
3. Press the button again and the display will
alternate between the last stored value and the
location to which it was assigned.
4. To display a different torque value stored in the
Peak Hold memory, use the
navigate to the desired location.
5. To exit, press
DTW38FL, DTW12FL
button stores the torque value.
button for 2-3 seconds.
buttons to
button four (4) times
Be sure the wrench is in Peak Hold Mode (P).
10 Rev. 01/23/13