Table of Contents
Advertisement
Before you begin-Read these instructions completely and carefully.
IMPORTANT: Save these instructions for local inspector's use.
IMPORTANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES.
NOTE TO INSTALLER: Be sure to leave these instructions with the Consumer.
NOTE TO CONSUMER: Keep these instructions with your Owner's Manual for future
reference.
This appliance must be properly grounded. See "Electric Supply", page 7.
CAUTION
WARNING
For Monogram local service in your area,
1-800-444-1845.
For Monogram Service in Canada,
Call 1-888-880-3030.
For Monogram Parts and Accessories, call
1-800-626-2002.
If you received a damaged range, you should
contact your dealer.
CAUTION:
THESE RANGES SHOULD BE INSTALLED
IN CONJUNCTION WITH A SUITABLE
OVERHEAD VENT HOOD. Due to the high
heat capacity of this unit, particular attention
should be paid to the hood and duct work
installation to assure it meets local building
codes.
Standard countertop and island installations:
A 1200 CFM hood is recommended for 48"
ranges.
A 600 CFM hood is recommended for 30" and
36" Ranges.
Hoods should be 24" min. deep and the same
width as the cooktop.
Check local building codes for the proper
method of gas range installation. Local codes
vary. Installation, electrical connections and
Design Information
Contents
Models Available ......................................................... 3
Accessory Requirements .......................................... 3
Models Dimensions and Clearances .................... 4,5
Advance Planning ....................................................... 6
Tools & Materials Required ....................................... 6
Power Supply Locations ............................................ 7
2
In the Commonwealth of Massachusetts:
• This product must be installed by a licensed plumber or gas fitter.
• When using ball type gas shut off valves, they shall be T-handle type.
• A flexible gas connector, when used, must not exceed 3 feet.
Installation of this range requires basic
electrical, carpentry and mechanical skills.
Proper installation is the responsibility of the
installer. Product failure due to improper
installation is not covered under the GE
Appliance Warranty. See the Owner's Manual
for details.
grounding must comply with applicable codes.
In the absence of local codes, the gas range
should be installed in accordance with the
National Fuel Gas Code ANSI 223.1, latest
edition and National Electrical Code ANSI/
NFPA 70, latest edition.
CAUTION:
These ranges weigh up to 600 pounds. Some
disassembly will reduce the weight consider-
ably. Due to the weight and size of the range
and to reduce the risk of personal injury or
damage to the product, TWO PEOPLE ARE
REQUIRED FOR PROPER INSTALLATION.
Step 1: Remove Packaging ........................................ 8
Step 2: Level the Range .............................................. 9
Step 3: Install Anti-Tip Device ................................... 9
Step 4: Connect Range to Gas ................................ 11
Step 5: Install the Range Backguard ..................... 11
Step 6: Connect Electrical ....................................... 12
Step 7: Slide Range Into Position ........................... 12
Step 8: Replace Oven Doors ................................... 12
Step 9: Assemble & Adjust Burners ...................... 13
Step 10: Adjustable Low Burner Settings ............. 13
Finalize Installation ................................................... 13
Hide quick links:
Advertisement
Table of Contents
