Table of Contents
Advertisement
About this task
The figure indicates the location of the hard-drive assembly module and provides a visual representation of the installation
procedure.
Steps
1. Place the hard-drive assembly on the cover.
2. Route the hard-drive cable through the routing guide on the chassis.
3. Connect the hard-drive cable to the connector on the system board and close the latch to secure the cable.
4. Turn the hard-drive assembly module and align the tabs on the hard-drive assembly with the slots on the chassis.
5. Align the screw hole on the hard-drive assembly with the screw hole on the chassis.
6. Replace the M2x3 screw to secure the hard-drive assembly to the chassis.
Next steps
1. Install the device on
Fixed stand/Pro 1 height-adjustable stand/Offset VESA mount/Pro 2 height-adjustable stand/Wall
mount.
2. Follow the procedure in
after working on your
device.
Removing and installing components
93
Advertisement
Table of Contents
