Window Regulators: Activating Automatic Open/Close Function; Vehicle Diagnostic Tester: Connecting - Audi R8 2015 Maintenance Manual

Audi R8 2015 ➤
Maintenance - Edition 03.2016
– Unscrew bolts -arrows-.
– Unfasten spreader rivet -2-.
– Repeat procedure on opposite side of vehicle.
– Remove noise insulation -1-.
Procedure for installing:
Install in reverse sequence. Note tightening torques (see table of
tightening torques for installation
2.4 Window regulators: activating automatic
open/close function
If the vehicle battery was disconnected, the automatic open/close
function for the electric windows must be reactivated.
Procedure:
– Pull up on window regulator switch until windows are com‐
pletely closed.
– Release switch and pull on it again for at least one second.
– Repeat procedure with all window regulators.
2.5

Vehicle diagnostic tester: connecting

Special tools and workshop equipment required
♦ Diagnosis system - VAS 6160 A-
♦ Remote diagnosis head - VAS 5054A-
♦ Or: Diagnosis interface - VAS 5055-
6
2. Preparations
⇒ page 5 ).
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.