Charcoal Filter - GE JVM1630 Owner's Manual

Charcoal Filter

(on some models)
The charcoal filter
cannot be cleaned. It
must be replaced. Order
Part No. WB02X10943
from your GE supplier.
To Remove
Charcoal Filter
Remove 2 grille screws
to remove the grille.
To Install
Charcoal Filter
If the model is not vented
to the outside, the air will
be recirculated through a
disposable charcoal filter
that helps remove smoke
and odors.
To remove the charcoal
filter, disconnect power
at the main fuse or circuit
breaker panel or pull
the plug.
To install a new filter,
remove plastic and other
outer wrapping from the
new filter.
1 Insert the top of the filter
up and into the grooves
on the inside of the top
opening.
The charcoal filter should
be replaced when it is
noticeably dirty or
discolored (usually after
6–12 months, depending
on hood usage). See
"Optional Kits," page 9,
for more information.
Remove the top grille by
removing the 2 screws that
hold it in place. Pull the
filter at the bottom until it
comes free of the locking
tabs. Slide the filter down
and out.
2 Push the bottom of the
filter in until it snaps
into place behind the
locking tabs.
35