Table of Contents
Advertisement
Installation
REMOVE ALL THE SHIPPING PARTS BEFORE INSTALLATION
LOCATION
• Select a location that can support the weight of the air conditioner and one that
will not cause increased operation noise and vibration.
• Direct sunlight is not favourable for efficient cooling.
• Select a place where there is limited obstacles near the air inlet and outlet.
Less than 210
More than 55
wall thickness is less than 210
Make rear side lower so that waterwill drain out smoothy.
10
45
Scrape
lf the wall thickness is more than 210 scrape the wall as
shown above.
less
than 210
more
more
than 400
than 400
more
than 500
Installation
CAUTION
• Do not install air conditioner in a place where flammable gas leaks are a
possibility.
• The minimum clearance from the appliance to combustible surfaces is 100mm;
(Only for electric heating)
• The range of external static pressures at which the appliance was tested is 0-5Pa.
• Before installation, turn off the operation switch and disconnect the power cord.
• This appliance is not intended for use by individuals (including children) with
reduced physical, sensory or mental capabilities, or a lack of experience or
knowledge, unless there is supervision or instruction concerning use of the
appliance from a person responsible for their safety.
• The appliance is fitted with means for disconnection. The supply mains have
a contact separation in all poles that provide full disconnection for voltage
category III conditions, and this means it must be incorporated in the fixed wiring
in accordance with the wiring rules.
OPERATION
• Check the capacity of wiring and power outlet. The power outlet should be used
exclusively for this air conditioner. Do not use it with other appliances.
• Ground the air conditioner to prevent the danger of electric shocks.
• Connect the air conditioner with its' power source securely.
• Use a fuse as above.
11
Advertisement
Table of Contents
