Xerox WorkCentre 3215 Service Manual page 28

05-500 Document Feeder Cover Open Fault
The Document Feeder or Document Feeder Top Cover is not securely latched.
BSD-Reference: 5.1A Automatic Document Feeder
Initial Actions
• Close the Document Feeder unit.
• Close the Document Feeder top cover.
Procedure
Check the cicuit between the ADF Cover Sensor and the Main PWB. The circuit is good.
Y N
• Check that there is no contamination present.
• Check for broken or defective wires or cables.
• Replace parts as required PL
Replace the Main PWB (REP 1.8) PL 1.1.
Status Indicator RAPs
05-500 , 06-100 / 200
1.1.
06-100 / 200 LSU Motor Fault
06-100 - LSU Motor Lock Error: The machine has detected that the Laser Module Drive Motor
is not working correctly.
06-200 - LSU HSync Error: The machine has detected that the Laser Module Drive Motor is not
working correctly.
BSD-Reference: 6.1 LSU
Procedure
Do not perform repair activities with the power on or electrical power supplied to the
machine. The machine could activate and cause serious personal injury when the power
is on or electrical power is supplied.
DANGER: Ne pas effectuer de dépannage avec le contact principal activé ou avec l'ali-
mentation électrique appliquée à la machine: celle-ci pourrait démarrer et causer de
graves blessures.
AVVERTENZA: Non effettuare alcuna riparazione con la macchina accesa o con l'ali-
mentazione elettrica inserita. La macchina potrebbe avviarsi all'improvviso e causare
gravi ferite.
VORSICHT: Es dürfen keine Reparaturarbeiten durchgeführt werden, solange das Gerät
eingeschalten oder mit der Stromquelle verbunden ist. Das Gerät kann u.U in den Aktiv-
Zustand übergehen und somit erhebliche körperliche Schäden verursachen.
AVISO: No realice reparaciones con la máquina encendida o conectada a la corriente. La
máquina podría activarse y ocasionar daños personales graves.
Use eye protection when performing the following procedure. Failure to wear eye pro-
tection could result in serious personal injury.
DANGER: Porter des lunettes de sécurité pendant la procédure suivante. À défaut, de
graves blessures peuvent se produire.
AVVERTENZA: Indossare occhiali di protezione durante la seguente procedura. In caso
contrario, si possono provocare gravi ferite.
VORSICHT: Folgende Verfahren dürfen nicht ohne Schutzbrille angewandt werden. Die
Nichteinhaltung dieser Regel kann zu ernsthaften körperlichen Verletzungen führen.
AVISO: Use gafas de protección para realizar el procedimiento siguiente. No proteger
los ojos puede ocasionar daños personales graves.
Enter Diagnostic (EDC) Mode. Select: [DC330 Component Control, 110 LSU, LSU Mot1
Run] to test the LSU motor. The motor runs.
Y N
Check the Main Wire Harness and connectors on the Laser Module, (BSD 6.1). The
connections are secure.
Y N
• Check that there are no broken or defective wires and that no contamination
present.
• Disconnect and securely reconnect the harness
Check the Harness for an open or short circuit. The harness is OK.
A
June 2014
2-6 Xerox® WorkCentre® 3215/3225 Multifunction Printer Service Manual
WARNING
WARNING