Canon DR-3080CII Startup Manual page 22

IMPORTANT
● Make sure that the scanner and your PC are both turned off when
connecting the scanner to the PC.
● The factory default setting for the terminator of the scanner is set to ON as
default. Be sure to turn off all terminators of the SCSI devices connected
between the scanner and the PC.
Note
The factory default setting for the SCSI ID is "2".
You can set the SCSI ID by using the DIP-switch provided on the rear side of
the scanner. In the DIP-switch settings, the SCSI ID can be set to ON by
turning the switch to the upper position, or OFF by turning it to the lower
position.
Default Settings
(SCSI ID = 2)
2
1
ON
Refer to the following table when setting the SCSI ID. If there are other SCSI
devices connected to or inside the PC, make sure to set a unique ID for the
scanner.
SCSI ID SW1
2
3
4
5
20
Installing the Scanner
DIP Switch
SW2
OFF OFF
OFF ON
ON OFF
ON ON