Intended Use; Definitions: Safety Guidelines; Important Safety Instructions For All Battery Chargers - Stanley SC201 Original Instructions Manual

Table of Contents

Advertisement

Available languages

Available languages

  • ENGLISH, page 1

INTENDED USE

Your STANLEY SC201-SC202 chargers has been designed
for charging STANLEY 18V Li-Ion battery packs. This
appliance is intended for professional use.

DEFINITIONS: SAFETY GUIDELINES

The definitions below describe the level of severity for each
signal word. Please read the manual and pay attention to
these symbols.
DANGER: Indicates an imminently hazardous
situation which, if not avoided, will result in death or
serious injury.
WARNING: Indicates a potentially hazardous
situation which, if not avoided, could result in death
or serious injury.
CAUTION: Indicates a potentially hazardous
situation which, if not avoided, may result in minor
or moderate injury.
NOTICE: Indicates a practice not related to
personal injury which, if not avoided, may result in
property damage.
Denotes risk of electric shock.
Denotes risk of fire.
WARNING: To reduce the risk of injury, read the
instruction manual.
WARNING! Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future reference.
IMPORTANT SAFETY INSTRUCTIONS FOR ALL
BATTERY CHARGERS
Before using charger, read all instructions and cautionary
markings on charger, battery pack, and product using
battery pack.
WARNING: Shock hazard. Do not allow any liquid
to get inside charger. Electric shock may result.
CAUTION: Burn hazard. To reduce the risk of injury,
charge only STANLEY rechargeable batteries.
Other types of batteries may burst causing personal
injury and damage.
CAUTION: Children should be supervised to ensure
that they do not play with the appliance.
NOTICE: Under certain conditions, with the charger plugged
in to the power supply, the charger can be shorted by foreign
material. Foreign materials of a conductive nature such as, but
not limited to, grinding dust, metal chips, steel wool, aluminum
foil, or any buildup of metallic particles should be kept away
from charger cavities. Always unplug the charger from the
power supply when there is no battery pack in the cavity.
Unplug charger before attempting to clean.
(Original instructions)
DO NOT attempt to charge the battery pack with any
charger other than the ones in this manual. The
charger and battery pack are specifically designed to work
together.
These charger are not intended for any uses other
than charging STANLEY rechargeable batteries. Any
other uses may result in risk of fire, electric shock or
electrocution.
Do not expose charger to rain or snow.
Pull by plug rather than cord when disconnecting
charger. This will reduce risk of damage to electric plug
and cord.
Make sure that cord is located so that it will not be
stepped on, tripped over, or otherwise subjected to
damage or stress.
Do not use an extension cord unless it is absolutely
necessary. Use of improper extension cord could result in
risk of fire,electric shock, or electrocution.
Do not place any object on top of charger or place the
charger on a soft surface that might block the
ventilation slots and result in excessive internal heat.
Place the charger in a position away from any heat
source. The charger is ventilated through slots in the top
and the bottom of the housing.
Do not operate charger with damaged cord or plug —
have them replaced immediately.
Do not operate charger if it has received a sharp blow,
been dropped, or otherwise damaged in any way. Take it
to an authorised service centre.
Do not disassemble charger; take it to an authorised
service centre when service or repair is required. Incorrect
reassembly may result in a risk of electric shock,
electrocution or fire.
In case of damaged power supply cord the supply cord
must be replaced immediately by the manufacturer, its
service agent or similar qualified person to prevent any
hazard.
Disconnect the charger from the outlet before attempting
any cleaning. This will reduce the risk of electric shock.
Removing the battery pack will not reduce this risk.
NEVER attempt to connect 2 chargers together.
The charger is designed to operate on standard 230V
household electrical power. Do not attempt to use it on any
other voltage. This does not apply to the vehicular charger.
Save these instructions
CHARGER
The SC201 / SC202 chargers accepts 18V Li-ion battery
packs. The charger require no adjustment and is designed to
be as easy as possible to operate.
ENGLISH
3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sc202

Table of Contents