Adjusting Display Contrast, Brilliance; Choosing A Display, Frequency - Furuno LS-4100 Operator's Manual

5" echo sounder
Table of Contents

Advertisement

ROM : OK
Program No: 0252318-01.**
** Program version no.
Start-up screen
To turn off the power, press and hold
down the [POWER/BRILL] key until the
screen goes blank. The time remaining
until power is turned off is counted down
on the screen.
Note: The example screens shown in
this manual may not match the screens
you see on your display. The screen
you see depends on your system
configuration and equipment settings.
1.3 Adjusting Display
Contrast, Brilliance
1. Press the [POWER/BRILL] key
momentarily to show the
brilliance/contrast adjustment
window.
CONTST
BRILL
Brilliance/contrast adjustment window
2. For contrast, press the
[POWER/BRILL] key to adjust
contrast cyclically. (You may also use
◄ or ► on the Cursor Pad to adjust
contrast.) (Adjustable range: 0 to 9)
3. To adjust brilliance, use ▲ or ▼.
(Adjustable range: 0 to 4)
4. Press the [MENU/ESC] key to close
the brilliance/contrast adjustment
window.
RAM : OK
Min
Max
4
Min
Max
4
Note 1: When the power is reapplied
after turning off the equipment with
minimum brilliance, minimum brilliance
will be set after the equipment goes
through its initial start up. (The start up
screen appears with the maximum
brilliance.) Adjust the brilliance as
necessary.
Note 2: Setting windows other than
those on menus are erased if there is
no operation within about seven
seconds.
1.4 Choosing a Display,
Frequency
Seven displays are available: single
frequency (50 or 200 kHz), dual
frequency, marker-zoom, bottom-zoom,
bottom-lock, and nav data (two
displays).
1. Press the [MODE] key to show the
mode selection window.
SINGLE FREQ.
DUAL FREQ.
MARKER ZOOM
BOTTOM ZOOM
BOTTOM LOCK
NAV DATA-1
NAV DATA-2
50kHz
Mode selection window
2. Press the [MODE] key again within
seven seconds to choose a mode.
You may also choose a mode with ▲
or ▼.
3. For modes other than DUAL FREQ,
choose frequency. Press ◄ for 50
kHz or ► for 200 kHz.
4. Press the [MENU/ESC] key to close
the window.
2
MODE
200kHz

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ls-4100thLs-4100tm

Table of Contents