Ir Learning Device; Bt Work Mode; C 388 As A Bluetooth Sink - NAD C 388 Owner's Manual

IR LEARNING DEVICE

Source Setup
IR Learning Device
AMP
IR Learning Device enables any non-NAD remote control to learn AMP
and BluOS basic remote control codes. With the learned codes, use the
configured non-NAD remote control to command or operate the C 388.
HOW TO LEARN REMOTE CONTROL CODES
1 Go to IR Learning Device menu. Select either AMP or BluOS.
2 Select AMP and the first Amp Learning Key appears – VOLUME UP.
Source Setup
Amp Learning Key
VOLUME UP
3 Press ENTER to select VOLUME UP and initiate learning mode.
Source Setup
VOLUME UP
Learning...
4 Direct or point the non-NAD remote control to the IR sensor in the
front panel. Then, press desired button on the non-NAD remote
control where VOLUME UP will be learned. Upon pressing the
designated button, display will turn to "Learned".
Source Setup
VOLUME UP
Learned
5 "VOLUME UP" is now learned into the designated button. Repeat
the same for the other codes to be learned. The same procedure
applies for BluOS learning.

BT WORK MODE

Settings Settings
Bluetooth (BT) Work Mode defines the two roles of the C 388 as either a
Bluetooth Sink or a Bluetooth Source.

C 388 AS A BLUETOOTH SINK

Settings Settings
Set "BT Work Mode" to "Sink". Initiate pairing of your Bluetooth device with
C 388 by following below procedure.
1 Ensure that the Bluetooth antenna is connected to the BT antenna
Settings Settings
2 Select "Bluetooth" as a Source. Display shows "Discoverable".
3 Using your iOS or Android device, go to Settings – Bluetooth and then
4 At "Discoverable" mode, the unique device ID of your C 388 is listed or
Settings Settings
5 Upon successful pairing of your Bluetooth device and the C 388, display
Source Setup
BT Work Mode
Sink
Sink: Audio stream is received from a Source on the same Bluetooth
network environment.
Source: Audio is streamed or sent to another device (Sink) on the same
Bluetooth network environment.
terminal at the rear panel.
Source Setup
Bluetooth(Sink)
Discoverable
scan for Bluetooth devices.
selectable in the device list of your Bluetooth settings. Pair or connect
your C 388 and Bluetooth device.
will change to "Connected" and then "Playing" when music is played
from your Bluetooth device.
Source Setup
Bluetooth(Sink)
Connected
Source Setup
Bluetooth(Sink)
Playing
OPERATION
USING THE C 388
Settings Settings
Settings
Settings
Settings
17