Polaris 340 CLASSIC 2006 Manual page 128

ENGINE
11. Remove the cable tie (3) that secures the DET wire to the
exhaust valve vent line.
12. Squeeze the vent line clamps and remove the exhaust
valve vent lines from the top of the exhaust valve base.
13. Disconnect the DET connections (4) that is located above
the carburetors and intake boots.
4
14. Remove the cable tie holding the water temperature sensor
to the thermostat hose and disconnect the water
temperature sensor (5).
5
6.16
3
15. Disconnect the throttle position sensor (TPS) from the
carburetor.
16. Disconnect the Regulator Rectifier (6) and the Stator
connections (7). These are located behind the brake disc
area.
17. Loosen up the boot clamps that hold the carburetor onto
the intake.
18. Separate the carburetors from the engine.
19. Disconnect the oil supply lines from the carburetor and
secure the carburetor assembly out of the way.
NOTE: Plug the carburetor areas with a clean shop
towel to keep any debris from entering the
carburetors.
20. Drain the engine coolant.
NOTE: Disconnect the thermostat hose (5) and
place the end into a container. Compress air in to
the system through the thermostat and coolant
should come out of the hose.
21. Move the thermostat hose clamp up onto the shoulder of
the thermostat fitting (8). Remove the hose and secure it
out of the way.
8
6
7