Table of Contents
Advertisement
Specifications
Width of Cut: 62 in.
Height-of-Cut: Adjustable from 1-1/2" to 4-1/2" in 1/2" incre-
ments.
Cutter Housing: 4" deep housing is made of 12 gauge steel and
reinforced with 10 gauge channel and plates.
Cutting Unit Drive: Isolation mounted gear box on the cutting unit
is driven by PTO shaft. Power is transmitted to the blades by one
hex "AA" section belt. Spindle shafts are 1 inch diameter and sup-
ported by two greaseable, tapered roller bearings.
Cutting Unit Blades: Three 21-3/4" long and 1/4" thick heat treat-
ed steel, Recycler blades .
Castor Wheels: Front and rear castor wheels have 8 in. x 3.50 in.
hard rubber tires and roller bearings.
Cutting Unit Lift: Independent lift arms and hydraulic weight
transfer provide deck flotation.
Weight: 340 lb.
Specifications and design subject to change without notice.
Before Operating
CHECK THE LUBRICANT IN THE GEAR
BOX
The gear box in designed to operate on SAE 80-90 weight. gear
lubrication. Although the gear box is shipped with lubricant from
the factory, check the level before operating the cutting unit.
1.
Position the machine and cutting unit on a level surface.
2.
Remove the check plug from side of the gear box and make
sure the lubricant is up to the bottom of the hole. If lubricant
level is low, remove the fill plug on top of the gear case and
add enough lubricant to bring it up to bottom of the hole in the
side.
Figure 1
1.
Filler plug
2. Check plug
9
Advertisement
Table of Contents
