Table of Contents
Advertisement
• Engine could start accidentally.
• Accidental starting of engine could cause serious injury to
operator or bystanders.
• Shut engine off and remove key from ignition switch before
performing any maintenance or adjustments
SEPARATING THE CUTTING UNIT FROM
THE TRACTION UNIT (Fig 9–11)
1.
Position the machine on level surface, lower the cutting unit to
the floor, move the lift lever to the float position, shut the
engine off and engage the parking brake.
2.
Remove the capscrews, flatwashers and locknuts securing the
ball joint mounts to the castor arms on the cutting unit.
3.
Roll the cutting unit away from the traction unit separating
male and female sections of the PTO shaft.
• Engine could start accidentally.
• Accidental starting of engine could cause serious injury to
operator or bystanders.
• Shut engine off and remove key from ignition switch before
performing any maintenance or adjustments
MOUNTING THE CUTTING UNIT TO THE
TRACTION UNIT (Fig 9–10)
1.
Position the machine on a level surface and shut the engine off.
2.
Move the cutting unit into position in front of the traction unit.
3.
Slide the male PTO shaft into the female PTO shaft.
4.
Move the lift lever to the FLOAT position. Push the lift arms
down until the holes in ball-joint mounts line up with the holes
CAUTION
CAUTION
Figure 9
1.
Castor arm
2.
Ball joint mount
Figure 10
1.
PTO Shaft
15
Advertisement
Table of Contents
