Customizing The Equalizer Curve; Eq7 Tune; Adjusting The Speaker Volume - Sony MEX-DV1600U Operating Instructions Manual

Customizing the equalizer curve

— EQ7 Tune

"CUSTOM" of EQ7 allows you to make your
own equalizer settings. You can adjust the level
of 7 different bands: 62 Hz, 157 Hz, 396 Hz,
1.0 kHz, 2.5 kHz, 6.3 kHz, and 16 kHz.
1
During reception/playback, press
(SYSTEM SETUP).
The system setup item appears on the main
unit.
2
Press M/m to select "EQ7 TUNE," then
press (ENTER).
3
Press M/m to select "CUSTOM," then
press (ENTER).
4
Adjust the level of each frequency.
To adjust the level, press M/m.
The level is adjustable in single steps,
between –8 and +8.
To switch the frequency, press </,.
To restore the factory-set equalizer curve,
press and hold (ENTER).
5
Press (ENTER).
The setting is complete and the display
returns to normal play/reception mode.
To hide the system setup display, press
(SYSTEM SETUP).
Tip
Other equalizer types are also adjustable.
With the main unit
Press and hold the control dial instead of pressing
(SYSTEM SETUP), rotate the control dial instead of
pressing M/m, press (SEEK) –/+ instead of </,,
press the control dial instead of (ENTER).

Adjusting the speaker volume

You can adjust the volume of each connected
speaker.
1
Press (SYSTEM SETUP) while the unit is
off.
The system setup item appears on the main
unit.
2
Press M/m to select "SP SETUP," then
press (ENTER).
3
Press (ENTER) to select "LEVEL-ADJ."
4
Adjust the volume of each speaker.
To adjust the level, press M/m.
The level is adjustable in single steps,
between –6 and +6.
To switch the speaker, press </,.
The speaker switches as follows:
FL (Front Left) t FR (Front Right) t
SR (Rear Right) t SL (Rear Left) t
SUB* (Subwoofer)
* Appears only when "REAR/SUB" is set to "SUB
OUT" (page 45).
5
Press , repeatedly until the clock
display appears.
The setting is complete.
With the main unit
Press and hold the control dial instead of pressing
(SYSTEM SETUP), rotate the control dial instead of
pressing M/m, press (SEEK) –/+ instead of </,,
press the control dial instead of (ENTER).
39