Table of Contents
Advertisement
This chapter details how to install the ATI FireMV/ATI FirePro graphics card into
your computer.
Installing a Graphics Card
Make sure you have completed the preinstallation steps outlined in
Started
on page 1.
Please read all installation instructions completely before you begin.
1.
Turn off your computer, monitor(s), and other peripheral devices.
2.
Unplug the computer's power cord and disconnect all cables from the back
of the computer.
Caution:
Wait approximately 20 seconds after unplugging the power cord before
disconnecting a peripheral or removing a component from the
motherboard to avoid possible damage to the motherboard.
3.
Remove the cover to your computer's case.
Note: If necessary, consult your computer's manual for help in
removing the cover.
Caution:
Static electricity can seriously damage computer components. Discharge
your body's static electricity by touching the power supply or the metal
surface of the computer chassis before you touch any components inside
your computer's case to avoid damaging them.
4.
Unscrew or unfasten and remove any existing graphics card from your
computer.
Note: If the computer has an on-board graphics capability, you may
need to disable it on the motherboard. For more information, see your
motherboard documentation.
5.
Locate the appropriate slot and, if necessary, remove the metal back-plate
cover. Make sure all internal cables are clear of the slot.
6.
Align your ATI FireMV/ATI FirePro graphics card with the slot and press it
in firmly until the card is fully seated. You may need to hold open a locking
tab on the slot with your finger when you seat the card.
7.
Screw in or fasten the graphics card securely.
8.
Make sure no internal cables are interfering with anything inside the
computer (for example, a cooling fan) and replace the computer cover.
Hardware Installation
Chapter 2
Getting
Advertisement
Table of Contents
