Directly Access Through Ie - Motorola hellosecurity User Manual

2 megapixel lpr network camera

Table of Contents

Network Camera User Manual

The system will pop up the above-mentioned textbox to ask you to change the default

password. It is strongly recommended to change the default password for account security. If

"Do not show again" is checked, the textbox will not appear next time.

2.1.2 Directly Access through IE

The default network settings are as shown below:

IP address: 192.168.226.201

Subnet Mask: 255.255.255.0

Gateway: 192.168.226.1

HTTP: 80

Data port: 9008

Use the above default settings when logging in the camera for the first time. Directly connect

the camera to the computer through network cable.

① Manually set the IP address of the PC and the network segment should be as the same as

the default settings of the IP camera. Open the network and share center. Click "Local Area

Connection" to pop up the following window.

Select "Properties" and then select internet protocol according to the actual situation (for

example: IPv4). Next, click the "Properties" button to set the network of the PC.

Table of Contents