Wheel And Tyre Combinations - Mercedes-Benz S-Class 2013 Owner's Manual

Hide thumbs Also See for S-Class 2013:
Table of Contents

Advertisement

Lowering the vehicle
G
WARNING
The wheels could work loose if the wheel nuts
and bolts are not tightened to the specified
tightening torque. There is a risk of accident.
Have the tightening torque immediately
checked at a qualified specialist workshop
after a wheel is changed.
Place the ratchet ring spanner onto the
X
hexagon nut of the jack so that the letters
AB are visible.
Turn the ratchet ring spanner until the vehi-
X
cle is once again standing firmly on the
ground.
Place the jack to one side.
X
Tighten the wheel bolts evenly in a cross-
X
wise pattern in the sequence indicated
(: to A). The tightening torque must be
150 Nm.
Turn the jack back to its initial position.
X
Stow the jack and the rest of the vehicle
X
tools in the boot again.
AMG vehicles and vehicles with AMG
X
equipment: insert the cover into the outer
sill.
Check the air pressure of the newly fitted
X
wheel and adjust accordingly.
Observe the recommended tyre pressure
(
page 443).
Y
i
Vehicles with a tyre pressure control sys-
tem: all fitted wheels must be equipped
with functioning sensors.

Wheel and tyre combinations

Wheel and tyre combinations
General notes
! For safety reasons, Mercedes-Benz rec-
ommends that you only use tyres and
wheels which have been approved by
Mercedes-Benz specifically for your vehi-
cle.
These are specially adapted to the control
systems, such as ABS or ESP
marked as follows:
MO = Mercedes-Benz Original
R
MOE = Mercedes-Benz Original Extended
R
(tyres featuring run-flat characteristics)
MO1 = Mercedes-Benz Original (only cer-
R
tain AMG tyres)
Mercedes-Benz Original Extended tyres
may only be used on wheels that have been
specifically approved by Mercedes-Benz.
Only use tyres, wheels or accessories tes-
ted and approved by Mercedes-Benz. Cer-
tain characteristics, e.g. handling, vehicle
noise emissions or fuel consumption, may
otherwise be adversely affected. In addi-
tion, when driving with a load, tyre dimen-
sion variations could cause the tyres to
come into contact with the bodywork and
axle components. This could result in dam-
age to the tyres or the vehicle.
Mercedes-Benz accepts no liability for
damage resulting from the use of tyres,
wheels or accessories other than those tes-
ted and approved.
Further information about wheels, tyres
and approved combinations can be
obtained from any qualified specialist
workshop.
! Retreaded tyres are neither tested nor
recommended by Mercedes-Benz, since
previous damage cannot always be detec-
ted on retreaded tyres. As a result,
Mercedes-Benz cannot guarantee vehicle
safety if retreaded tyres are fitted. Do not
fit used tyres if you have no information
about their previous usage.
455
®
and are
Z

Advertisement

Table of Contents
loading

Table of Contents