Removing The Tpu Unit Cable - Epson Perfection V500 Photo Service Manual

EPSON Perfection V500 Photo

4.2.13 Removing the TPU Unit Cable

1. Remove the TPU Lower Housing.
2. Remove the left and right Hinges.
3. Remove the C.B.P. M3 x 8 screw that secures the TPU Unit Cable.
4. Disconnect the TPU Unit Connector CN1 from the DRV Board.
5. Release the TPU Unit Cable from the notches shown in the figure below.
Cable Tie
Notches
Figure 4-33. Removing the TPU Unit Cable
DISASSEMBLY / ASSEMBLY
See Section 4.2.10 on page 43.
See Section 4.2.12 on page 44.
C.B.P. 3 x 8
(4.5±0.5kgf.cm)
DRV Board
TPU Unit Cable
CN1
When installing the TPU Unit Cable, put the cable and the
cable tie into the notches as shown in
When connecting the TPU Unit Cable to the DRV Board, route
the cable as shown in the figure below.
Disassembly Procedure
Figure
TPU Unit Cable
DRV Board
Ground
Figure 4-34. Routing the TPU Unit Cable
Revision A
4-33.
45