Removing The Sensor Board; Removing The Hinge Assy - Epson Perfection V500 Photo Service Manual

EPSON Perfection V500 Photo

4.2.11 Removing the Sensor Board

1. Remove the TPU Lower Housing.
2. Remove the C.B.P. M3 x 8 screw that secures the Sensor Board.
3. Disconnect the Sensor Connector CN1 while lifting the Sensor Board, and remove
the Sensor Board.
Figure 4-31. Removing the Sensor Board
DISASSEMBLY / ASSEMBLY
See Section 4.2.10 on page 43.
Sensor Board
C.B.P. 3 x 8
(6.5±0.5kgf.cm)
CN1

4.2.12 Removing the Hinge Assy.

1. Remove the TPU Lower Housing.
2. Remove the four C.B.P. M4 x 12 screws that secure the left and right Hinge Assy.s
and remove them.
Disassembly Procedure
See Section 4.2.10 on page 43.
C.B.P. 4 x 12
(6.5±0.5kgf.cm)
Figure 4-32. Removing the Hinge Assy.
Revision A
44