Woods TURF BATWING TBW150C Operator's Manual page 33

Table of Contents

Advertisement

Mulch Kit Installation
NOTE: Do not tighten hardware until mulch kit is com-
pletely installed.
1. Raise deck and lock into transport position.
NOTE: Make sure deck is stable before proceed-
ing.
2. Remove
chain
shielding
shielding is not required when using mulch kit.
3. Attach mulch kit frame to bottom of deck using
carriage bolts (4) and flange lock nuts (5). Make
sure head of carriage bolts are on the underside of
the deck.
NOTE: Rotate blades and check for interference
with mulch kit frame. Failure to do so could result
damage or possible injury once mower is operated.
Adjust frame as necessary.
4. Attach the two support brackets (1) to the mulch kit
frame using carriage bolts (2) and flange lock nuts
(3). Make sure head of carriage bolt are on the
blade side of the frame.
5. Using the support brackets as a template mark and
drill two 11/32" holes into the deck baffles.
6. Secure support brackets to baffles using carriage
bolts (2) and flange lock nuts (3). Make sure head
of carriage bolts are on the blade side of the frame.
7. Tighten all hardware.
MAN0765 (12/5/2008)
if
installed.
Chain
A. Mulch kit frame
1. Support bracket
2. 5/16 x 3/4 Carriage bolt
3. 5/16 NC flange lock nut
4. 3/8 NC x 1 Carriage bolt
5. 3/8 NC Flange lock nut
Figure 22. Mulch Kit Installation
Assembly 33

Advertisement

Table of Contents
loading

This manual is also suitable for:

Turf batwing tbw12.20

Table of Contents