GE ETS19 P Series Technical Service Manual page 9

https://appliancetechmanuals.com
7. Remove the 2 screws from the bottom of the
tower housing.
8. Lift up and pull the tower housing forward,
making sure the bottom notch comes out of
and clears the freezer floor.
9. Remove the tower housing.
Tower Housing
Screw
10. Remove the two screws from the evaporator
cover.
11. Remove the two screws from the fan bracket
and pull the evaporator cover forward.
Note: If necessary, bow the evaporator cover
outward until it clears the ice maker receptacle.
12. Depress the clip and pull the socket out far
enough to access the electrical connector.
Note: If necessary, reach behind the evaporator
cover to access the electrical connector.
13. Disconnect the electrical connector from the
light socket and remove the socket.
14. Remove the evaporator cover.
Evaporator Cover
Screw
Screw
Socket
Clip
Screw
Electrical
Connector
15. Disconnect the electrical connector from the
evaporator fan motor.
16. Slide the evaporator fan blade off the motor
shaft.
17. Remove the evaporator fan motor screws and
grounding wire from the evaporator fan
bracket.
18. Remove the front evaporator fan bracket and
motor.
19. Remove and retain the front blue isolation
grommet from the motor shaft.
Screw
20. Make sure the rear blue isolation grommet is
seated properly on the motor mounting
bracket prior to installation of the new
evaporator fan motor.
– 9 –
Blade
Electrical
Connector
Bracket
Screw and
Ground Wire
Grommet