Using The Current Output Modes - Fluke 715 Instruction Sheet

All manuals and user guides at all-guides.com

Using the Current Output Modes

The calibrator provides current output in mA or percent display.
Percent is -25.00 to 125.00%, where 0% is 4 mA, and 100% is 20
mA.
In source mode, the calibrator supplies the current. In simulate
mode, the calibrator simulates a two-wire transmitter in an
externally-powered current loop.
Sourcing mA
Use source mode whenever you need to supply current into a
passive circuit such as a current loop with no loop supply. Insert
the test leads into the OUTPUT + and − mA jacks as shown
below.
A path must exist for current to flow between the
OUTPUT + and −mA jacks, otherwise the display will
indicate an overload (OL) when you set an output value.
Press to step up/down
4 mA (25%)
Shop for Fluke products online at:
715 English Instruction Sheet
Note
OUTPUT
715 VOLT/mA CALIBRATOR
V mA
%
mV
Press so that
INPUT
+ LOOP mA COM V
OUTPUT is on 30V 30V 30V
MAX MAX MAX
the display.
- mA SIMULATE, +
VOLTS
- mA +
OUTPUT (30V MAX)
TM
HART
Communicator
MyFlukeStore
www.
Page 8
mA Press to toggle
%
mA and % of
4-20 mA scale
Press to scroll
up/down 0.001 mA.
Hold down to scroll
faster.
it04i.eps
1.888.610.7664
.com