10
en | Installation procedure
4
Installation procedure
The initial installation of the PRA-APAS server is structured into the below steps which need to
be followed.
1.
2.
4.1
Network setup
The PRA-APAS server needs to be connected to a LAN or corporate network and to the
PRAESENSA network to which announcements should be sent from the PRA-APAS.
Notice!
i
Only one PRA-APAS device can be connected via ETH1 port to the PRAESENSA network.
Notice!
i
APAS is using internal network segment 172.18.0.0/16. Make sure that ETH1 and ETH2 ports
do not use this segment either statically configured or by DHCP.
Connection and functional diagram
2021-05 | V1.00 |
Network setup, page 10 .
Initial power on, page 12 .
3
4
COM
DC 12V
PRA-APAS
Configuration manual
Advanced public address server
PRAESENSA
HDMI
HDMI
1
2
Bosch Security Systems, B.V.