Table of Contents
Advertisement
57413
8/16/03
11:50 PM
Configuring Output
OUTPUT Screen
Use this screen to configure and test output signals.
➡ On the TRIGGER/OUTPUTS screen (#6.1), select
.
ENTER
FUNCTION
Select the condition upon which the sensor will emit an output signal:
Pass
: When judgment result is within taught limits.
Output Rdy
: (Output Ready) Upon each valid trigger. Indicates that a judgment has been made
and the output lines are valid.
Snsr Fail
: (Sensor Fail) When the sensor detects a hardware problem.
Fail Low
: When the count is less than the Pass Lo Limit (see page 24).
Fail High
: When the count is greater than the Pass Hi Limit (see page 24).
Fail
: When the judgment result is either Fail High or Fail Low.
➡ To toggle between choices, select
MODE
Select the type of circuitry inside the sensor that should drive the output signal:
sinking),
PNP
(current sourcing), or
➡ To toggle between choices, select
(Continued on page 30)
Banner Engineering Corp. • Minneapolis, MN
www.bannerengineering.com • Tel: 763.544.3164
Page 29
OUTPUT1
,
FUNCTION
and press
ENTER
Off
(inactive).
MODE
and press
ENTER
.
U.S.A.
OUTPUT2
OUTPUT3
, or
and press
.
NPN
(current
CONFIGURE
OUTPUT1 (white wire)
FUNCTION
Pass
MODE
PNP
TYPE
Pulsed
PULSEWIDTH 1
DELAY
0
msec
RESTORE
DONE
OUTPUT Screen
FUNCTION
Pass (Output1)
Fail (Output2)
Snsr Fail (Output3)
MODE
Off
TYPE
Latched
PULSEWIDTH
1 msec (If
TYPE
is set to Pulsed)
DELAY
0 msec
OUTPUT Screen Defaults
P/N 57413
29
Advertisement
Table of Contents
