Table of Contents
Advertisement
en
Operation
Warning!
The continuous-feed shredder must be
completely assembled before use. Never
assemble the continuous-feed shredder on
the base unit. Operate the continuous-feed
shredder in the indicated operating position
only.
Predetermined breaking point (Fig. E):
The built-in predetermined breaking point
protects the drive of the appliance. If an
overload occurs, the drive shaft of the
continuous-feed shredder breaks. However,
the drive shaft can easily be replaced. A
new disc holder with drive shaft is available
from customer service.
Reversible cutting disc –
thick / thin
for cutting food into thick or thin
slices, e.g. fruit and vegetables.
Marking:
■ 1 = thick slices
■ 3 = thin slices
Note: Not suitable for processing hard
cheese, bread, rolls or chocolate.
Tip: Only cut up cooked potatoes
once they have cooled down.
Reversible shredding disc –
coarse / fine
for shredding food coarsely or
finely, e.g. fruit, vegetables or cheese as
Gouda or Edam.
Marking:
■ 2 = coarse side
■ 4 = fine side
Note: Not suitable for processing nuts or
hard cheese, e.g. Parmesan.
Tip: Shred soft cheese with the coarse side
only.
Fine grating disc
for shredding food finely, e.g. nuts
or hard cheese such as Parmesan.
Note: Not suitable for processing soft
cheese and cheese slices.
26
Working with the continuous-feed
shredder
Fig. F:
■ Press the Release button and
move the swivel arm to
position 2.
■ Insert the bowl:
Tilt the bowl forwards and then set it
down. Turn anti-clockwise until it locks
into place.
■ Press the Release button and
move the swivel arm to
position 3.
■ Remove drive cover from the
drive of the continuous-feed shredder
(Fig. F-5a).
■ Hold disc holder at the lower end,
ensuring that the two tips are face up.
■ Carefully place the required slicing or
shredding disc onto the tips of the disc
holder (Fig. F-6a).
In the case of reversible discs, ensure
that the required side is face up.
■ Grip disc holder at the upper end and
insert into the housing (Fig. F-6b).
■ Attach the cover (note mark) and turn all
the way in a clockwise direction.
■ Place continuous-feed shredder on the
drive and rotate all the way in a clockwise
direction, as illustrated in Fig. F-8.
■ Turn rotary switch to recommended
setting.
■ Put food to be processed in the feed tube
and push down with the pusher.
Warning!
Prevent the cut ingredients from building up
in the outlet opening.
Tip: To ensure even cutting results, process
thin ingredients in bunches.
Note: If the food to be processed sticks in
the continuous-feed shredder, switch food
processor off, pull out mains plug, wait until
the drive comes to a standstill, remove
cover from the continuous-feed shredder
and empty feed tube.
Advertisement
Table of Contents
