Hyundai KONA N 2022 Owner's Manual page 59

Seats & Safety System
Automatic locking mode
Since all passenger seat belts move
freely under normal conditions and
only lock under extreme or emergency
conditions (emergency locking mode),
you must manually pull the seat belt all
the way out to shift the retractor to the
"Automatic Locking" mode to secure a
Child Restraint System.
The "Automatic Locking" mode will help
prevent the normal movement of the
child in the vehicle from causing the
seat belt to loosen and compromise
the Child Restraint System. To secure a
Child Restraint System, use the following
procedure.
To install a Child Restraint System on the
rear seats, do the following:
1. Place the Child Restraint System on a
rear seat and route the lap/shoulder
belt around or through the Child
Restraint System, following the Child
Restraint System manufacturer's
instructions. Make sure the seat belt
webbing is not twisted.
Information
When using the rear center seat belt, you
should also refer to the "Rear Seat Belt –
Passenger's 3-point system" section in this
chapter.
3-36
OHI038145
2. Make sure to insert the belt into the
guide (1) and check that the seat belt
is not twisted.
3. Fasten the lap/shoulder belt latch
into the buckle. Listen for the distinct
"click" sound.
Information
Position the release button so that it is easy
to access in case of an emergency.
OOS037030N
OHI038146