Blaupunkt Car CD Changer Operating Instructions Manual page 8

? SRC (source)
You can switch between the different
audio sources radio, tape, and CDC.
@ DIS
Radio operation
When pressing the DIS button, the fre-
quency will be displayed for approxi-
mately four seconds.
Tape operation
When pressing the DIS button, the sta-
tion name/frequency will be displayed
for approximately four seconds.
Changer operation
To switch the display mode and select
between name, time (playback time)
and number (disc number):
• Press DIS briefly.
A RM (Radio Monitor)
Press this button to listen to the radio
while fast forwarding or rewinding the
tape.
To switch RM on/off: Press RM.
34
When this function has been activated,
"RM" shows on the display panel.
The radio is played back during fast
tape run.
B
Press to eject the tape.
C 1, 2, 3, 4, 5, 6 - preset buttons
On FM, you can store six stations for
each of the memory banks I, II and T.
On MW/LW, you can store six stations
each.
To store a station: Press a preset
button during radio operation and hold
down until the set resumes play after
the muting and you hear a beep.
To recall a station: Select the desired
waveband. On FM, also adjust the
corresponding memory bank. Then
press the relevant preset button briefly.
Extra function preset buttons
To store and recall a PTY programme
type.
On FM, you can store and recall one
programme type on/from each preset
button when PTY is active ("PTY"
lights up in the display).
D Cassette loading slot
Insert the tape with side A or 1 facing
up, the open side showing to the right.
E
Tape side selector
Press this button to switch over to the
other side during tape operation. The
display shows "TR 1" or "TR 2".
F B
Dolby B NR*
Press this button to play back a tape
which has been recorded with Dolby-B
noise reduction. When this button is
pressed, „B" lights up in the display.
* Noise Reduction system manufactured under li-
cense from Dolby Laboratories Licensing Cor-
poration. „Dolby" and the double-D symbol are
trademarks of Dolby Laboratories Licensing Cor-
poration.
G LD
Loudness - When listening at a low
level, the Loudness function creates a
more natural sound by boosting the
low frequency range.
LD on/off: Press the button.
When the Loudness function is active,
"LD" will light up in the display.
See chapter "DSC programming" for
more information.