Power Cord Usage - Bissell PET HAIR ERASER 3 9 2 User Manual

A
ssembly
Attach vacuum hose and tools
1. Line up the tabs on the base of the Twist
'n Snap hose with the corresponding
notches on the hose collar as shown.
2. Turn the Twist 'n Snap hose to the left
to lock the hose into place.
3. Connect the curved hose wand to the hose.
Grasping the curved hose wand, slide the
end of the curved hose wand onto the hose
wand base. Snap the hose into the hose clip.
notE: the vacuum will not operate
effectively unless the curved hose wand
is firmly attached.
4. Slide the extension wand and crevice tool
together into the storage clip.
5. Slide the dusting brush/upholstery tool
into the storage clip.
6. Attach the Pet Contour Tool by aligning
the slots at the bottom with the tabs on the
upper tank cap, then snap back into the
two posts to secure.
7. Store Pet TurboBrush on the front of the
handle by lining up the TurboBrush base
with the base of the holder then push back
to snap into place.
8. Flip the pet hair lifter down until it clicks
into place on the front of the foot.
notE: Flip the Pet Hair Lifter down
for carpeted surfaces and up for non-
carpeted surfaces (see page 7 for more
information)
O
perations

Power cord usage

1.
Remove the cord and plug it into an electrical
outlet. There are two quick release cord wraps
for easy cord removal, and a cord clip that is
part of the upper cord wrap where you can
attach the cord when vacuuming.
2.
When finished cleaning, turn vacuum
cleaner off. Unplug power cord by grasp-
ing the polarized plug (NOT the cord) and
disconnect from outlet.
3.
Return Quick Release cord wrap to
original position and loop power cord
around cord wrap. Clip molded plug to
power cord to secure.
6
w w w . b i s s e l l . c o m
5.
4.
4.
Hose Wand
Base
7.
Quick Release
Cord Wraps
1.
3.
6.
8.
Pet Hair Lifter
8 0 0 . 2 3 7 . 7 6 9 1