Bissell PET HAIR ERASER 3 9 2 User Manual page 11

M
aintenance and care
Empty dirt container
the dirt container needs to be emptied
when the dirt reaches the "Full" line on
the container.
1.
Unplug the vacuum from electrical outlet.
2.
Slide the Lock 'n Seal Lever to the
"Unlock" position.
3.
Grasp handle and pull the dirt container
straight out to remove from the vacuum.
4.
Empty dirt into garbage container.
notE: Emptying the dirt container
after every use will help prevent
over filling and ensure that the
vacuum is ready to go the next time
you clean.
cleaning the pre-motor and post-motor HEPA media filter
1.
Unplug the vacuum from electrical outlet.
2.
The pre-motor filter protects the motor from
dirt particles. It is located in the slide out
tray underneath the dirt container. If the
filter becomes dirty, pull out the tray, lift
out the foam filter pad and clean it.
notE: the pre-motor filter may be
hand washed in cold water with mild
detergent. Rinse well and air dry thor-
oughly before replacing.
3.
The post-motor HEPA media filter assists
in the filtration process to return clean air
to the room. It is located behind the door
on the side of the vacuum. If the filter
becomes dirty, open the door, remove the
filter and replace.
notE: the post-motor filter is a white,
pleated HEPA media filter. this filter is
not washable and must be replaced
when it becomes dirty.
w w w . b i s s e l l . c o m
2.
Unlock
3.
Washable
Pre-Motor
Filter
WARnIng:
Do not operate cleaner with
damp or wet filters or
without all filters in place.
8 0 0 . 2 3 7 . 7 6 9 1
Post-Motor HEPA
Media Filter
11