Maintenance And Care - Bissell PROHEAT2X 8920 User Manual

M
aintenance and care
Machine care continued
5. before you place the cleaned 2-in-1
water tank back onto the machine,
remove the red solution filter cap (on the
base of the machine).Remove the cap
by inserting a coin or a flat head screw
driver into the slot on the top. turn coun-
ter clock wise and unscrew. set aside.
5a. Remove the white filter by grasping
the post and pulling up and out of
the unit. Rinse the filter under cold
water.
Note: Be careful not to drop
the filter into the sink or
disposal.
5b. Replace the white filter back into
the filter area.
Note: Make sure the white
filter is seated properly before
placing the red solution filter
cap.
5c. Replace the red solution filter cap
and turn clockwise to tighten.
6. Keeping the 2-in-1 water tank off of the
base of the machine, simply unscrew the
floor nozzle using a phillips head screw-
driver. this can be rinsed out at the fau-
cet. then replace back onto the machine
by starting from the bottom of the nozzle
and hooking the tabs into the holes on
the bottom sides of the machine. secure
into place with the screw.
w w w . b i s s e l l . c o m
5a.
solution
filter cap
5b.
5c.
filter
6.
8 0 0 . 2 3 7 . 7 6 9 1
17