Sanyo EM-CD2900UK Service Manual page 21

M.HOW TO RESET THE MEMORY OF ACCUMULATIVE M.HOW TO RESET THE MEMORY OF ACCUMULATIVE M.HOW TO RESET THE MEMORY OF ACCUMULATIVE M.HOW TO RESET THE MEMORY OF ACCUMULATIVE M.HOW TO RESET THE MEMORY OF ACCUMULATIVE
COOKING TIME COOKING TIME
COOKING TIME COOKING TIME COOKING TIME
After replacing the magnetron, reset each of
the accumulative cooking time.
1. Touch key.
2. Open and close the door, touch
and Ｍ key at the same time.
3. Push " 8 "," 8 "," 8 "," 1 "," "," ".
The display will show each of the accumula‑
tive cooking time which is selected in the
display window by the sign .
4. Each of the accumulative cooking time will
be selected by pressing the key as
follows.
MICRO OVEN GRILL OVEN+MICRO
GRILL+MICRO AUTO PREHEAT MICRO
OVEN......
5. Then touch the keys as follows.
" 0 "," Ｍ "
6. Selected mode accumulative cooking time will
be cleared.
NOTE:Total number of door operation can not be
cleared.
N.CAUTION FOR CUSTOMER ON OPENING AND CLOSING N.CAUTION FOR CUSTOMER ON OPENING AND CLOSING
N.CAUTION FOR CUSTOMER ON OPENING AND CLOSING N.CAUTION FOR CUSTOMER ON OPENING AND CLOSING N.CAUTION FOR CUSTOMER ON OPENING AND CLOSING
DOOR DOOR DOOR DOOR DOOR
When the Microwave oven is in operation,
should the customer open the door slightly
and close, the breaker of the house will
occasionally be cut off.
It is necessary to explain to the customer
not to exercise such matter.
When the door is opened slightly between 2
or 3mm distance,primary interlock switch turn
OFF,and operation stops.
However door sensing switch will remain ON,
and if door is closed,interlock switch ac‑
tivates and operation resumes immediately.
At such time microwave oven will start any
time.
Therefore a big In‑rush current flows,and
thus breaker will be cut off.
O. RELEASING TYPE CONNECTOR O. RELEASING TYPE CONNECTOR
O. RELEASING TYPE CONNECTOR O. RELEASING TYPE CONNECTOR O. RELEASING TYPE CONNECTOR
This oven is provided with locked type
connector. When you remove a connector,
pull the connector while releasing the
lock by pressing A point shown below.
Do not pull the wire of the connector.
A
Figure 24
Figure 26
‑ 20 ‑
A
Figure 25
Figure 27