Sanyo EM-CD2900UK Service Manual page 19

I I I I I
.CHANGING POWER SUPPLY CORD .CHANGING POWER SUPPLY CORD
.CHANGING POWER SUPPLY CORD .CHANGING POWER SUPPLY CORD .CHANGING POWER SUPPLY CORD
(See exploded view on page 25)
(1) Unfasten 1 screw for ground and pull out
the 2 wires of the power cord from the
noise filter.
(2) Remove 1 screw for the stay plate of the
cord bushing.
(3) Install the new power supply cord with the
reverse procedure of above(1)to(2).
WARING; WARING; WARING;
WARING; WARING;
For changing the power supply cord,never use
other than the following.
Key No. Order No. Parts name
24 617 180 3211 Cord bush
25 617 275 2624 Cord assembly
26 917 140 1340 Stay plate
J.REMOVING HEATER J.REMOVING HEATER J.REMOVING HEATER
J.REMOVING HEATER J.REMOVING HEATER
(Upper heater)
(1) Take off the cabinet.
(2) Remove 2 screws securing the upper heater
to the oven from inside of the oven cavity.
(3) Remove 2 screws securing the upper heater
to the oven cavity from outside the oven
cavity with 7 mm wrench.(Figure 21)
(Lower heater)
(1) Take off the cabinet and frame rear plate.
(2) Remove ceramic tray assembly following
G. Removing ceramic tray assembly proce‑
dure on page 16.
(3) Remove 2 screws securing the lower heater
to inside of the oven cavity.(Figure 22)
(4) Remove 2 screws securing the lower heater
to the oven cavity from outside of the oven
cavity with 7 mm box wrench.
Remove 1 screw for the bottom plate
of the cord bushing.
Remove 2 screws with 7 mm box wrench.
‑ 18 ‑
Figure 20
Figure 21
Remove 2 screws
Figure 22