Blocking Reception Of Unwanted Faxes - Sharp Facsimile UX-CC500 Operation Manual

Blocking Reception of Unwanted Faxes

STOP
5
Press
6
Set the reception mode to FAX.
When using distinctive ring, you must set the reception mode of your fax
machine to FAX. When your designated fax number is dialed, your fax will
automatically answer and begin reception after two rings. Note that other
devices on the same line will also ring until your fax answers. If one of your
other numbers is dialed, the fax will ring; however, it will not answer.
Blocking Reception of Unwanted Faxes
The Anti Junk Fax function allows you to block reception of faxes from a party
that you specify. This saves paper by not printing out unwanted "junk" faxes.
To use this function, follow the steps below to enter the fax number from which
you do not wish to receive faxes. One fax number can be entered.
1
FUNCTION
Press
2
Press
3
Press
4
Press
1
stored number (if you are clearing a number, go to Step 6).
5
Enter the fax number by pressing the number keys (max. 20 digits).
START/MEMORY
6
Press
display.
98
The display briefly shows
your selection, then:
to return to the date and time display.
once and 3 times.
once and twice.
once.
to store an Anti Junk number, or
and then press
RESOLUTION/
RECEPTION MODE
Display:
2
STOP
to return to the date and time
FAX SIGNAL RX
TEL
ENTRY MODE
ANTI JUNK #
1=SET, 2=CLEAR
to clear a previously
FAX
TAD