Table of Contents
Advertisement
Available languages
Available languages
REPlAcING THE HEAD KIT
Step 8: Fasten the lid to the ratchet head with lid screws.
See fig. 8
Test the functionality by making sure the driver turns and
the switch can pivot in both directions.
BEFoRE uSING THE WRENcH
BATTERY INSTAllATIoN
• Remove the battery cap.
• Insert two AA batteries (provided) matching the -/+
polarities of the battery to the battery compartment.
• Replace the battery cap and fasten it tightly
according to the illustrations.
SET uP
1.
U = Unit of Measure/Setting
2.
+ = increase measurement/ UP
- = Decrease measurement/ Down
3.
On/Off = Hold for 3 seconds to power off - Hold for 1
second to power on.
ETW38 and ETW12
Fig. 8
1
6
2
3
Rev. 02/27/15
Advertisement
Table of Contents
