Storing A Cue Point; Creating And Playing A Seamless Loop - American DJ Pro Scratch 1 User Manual

Professional compact disc player

Table of Contents

BASIC OPERATIONS (CONT.)

Storing A Cue Point:

Once you have set your CUE Point by one of the two means listed on page 12, you may store your cue point

in one of the FLASH BUTTONS (6). Either a CUE POINT or a SAMPLE (See creating a sample loop on page

14) can be stored into a FLASH BUTTONS (6), not both. Once you store this cue point in memory you may

recall it at any time and you may even recall if the disc has been remove or power had been disconnected.

You may store a maximum of three cue points per a disc and maximum of 384 cue points can saved

in unit's memory. The MEMORY BUCKET (53) on the LCD DISPLAY (1) will approximate the available

memory. To Store a cue point:

1) Press the MEMORY CUE BUTTON (12), as in Figure 17. The red Memory Cue LED will glow indicating

memory is ready to be stored. You may now press any one of the three FLASH BUTTONS (6) to store

your cue point into memory (Figure 18). After pressing one of the FLASH BUTTONS (6), the corresponding

Flash Button LED will flash briefly. The LED will remain lit indicating either a sample or cue point is stored

in memory. The red Memory Cue LED will now shut off.

2) Repeat the above steps to store up to three Cue Points. Once all your three cue points have been

stored you may access them at any time. The cue points will instantly start without any music interruption.

Please note in order to access these cue point, the disc used to create the cue points must be in the drive.

A seamless loop is a sound loop that plays continuously without sound interruption. You can use this loop to

create dramatic effect in your mixing. This loop has no time limit and you could actually loop the entire length

of disc. You create a seamless loop between two continuous points of a disc.

Figure 17

1) Press PLAY/PAUSE

BUTTON (15) to

activate playback

mode

Figure 19

American DJ

AUDIO • Pro Scratch 1™ INSTRUCTION MANUAL • PAGE 13

Figure 18

2) Press the IN BUTTON

(12). This will set the

starting point of the

SEAMLESS LOOP. The

IN BUTTON (12) LED

will light.

Figure 20

Table of Contents